If the slot number is omitted, you are prompted for the slot number. To exit from the Cisco IOS software image on the line card and return to the Cisco IOS image on the GRP card, use the exitcommand. 3 mainline, see the Cisco IOS Configuration Fundamentals and Network Management Command Reference, Release 1. Point-to-Point Protocol (PPP) is an open standard protocol that is mostly used to provide connections over point-to-point serial links. To identify the hardware platform or software image. Use the information in this chapter to configure LAN interfaces supported on Cisco routers and access servers. GNS3 is a software that simulate complex networks while being as close as possible from the way real networks perform, all of this without having dedicated. All versions are tested and are working with the latest version of GNS3. For documentation of commands in Cisco IOS Release 1.Äownload Cisco IOS for GNS3. For complete details on all debug commands, see the Cisco IOS Debug Command Reference. For detailed troubleshooting procedures and a variety of scenarios, see the Cisco IOS Internetwork Troubleshooting Guide publication. You can discover problems with the system monitoring commands, isolate problems with the system test commands (including debug commands), and resolve problems by reconfiguring your system with the suite of Cisco IOS software commands. To troubleshoot, you need to discover, isolate, and resolve the system problems. Troubleshooting and Fault Management Commands. Cisco IOS Configuration Fundamentals Command Reference, Release 1.
0 Comments
Leave a Reply. |